Below is an overview
of using the HUG System.

Download Manual (1meg )

At ground level the Hug and top safety bracket are nailed to the truss.

After securing the HUGS to the truss, the crane hoists them up onto the house or structure.

Installing the rail.
As easy as 1.....

2.....

3

At times it may be necessary to install HUGS from a ladder inside the structure as shown.

Creating a ladder rest.
Two HUGS are placed side by side and a safety lanyard is attached to the ladder.

With ladder at rest on top of the 2x6 slide guard rail, the roof edge will go undamaged.

Once the trusses and the HUG systems are in place, the truss ends (truss tails) are cut to length in safety and without obstruction.

After trimming the truss tails in line, a sub or finish fascia is attached to the home or structure.

Installing the plywood sheathing is dangerous, but with HUGS systems in place the process is safe & meets or exceeds OSHA requirements.

Sheathing made safe by HUGS.

Rooftop penetrations and tar papering made safe by HUGS.

All shingling and roof top finishes done in complete safety.

Safe and secure!

Our system allows complete roofing, siding, stucco and painting operations to be performed without interruptions.

Don’t get on a roof without HUGS!

Because when you climb down and go home you get real HUGS!